Нагуглил инструкцию:

DCard HxC Floppy Emulator Update procedure

DCard HxC Floppy Emulator Update procedure :

For users with the firmware V1.2.0.0 or above jump to the step 2) directly (No Bootloader update required)



1) Bootloader update (for users with a firmware below the version 1.2.0.0)

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!! Warning : DO NOT CUT the power supply of the board during the bootloader programming ! !!!
!!! In case of power loss, the device may be unusable and need a factory reprogramming. !!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

-> Copy the new bootloader file (HxC_SD_Bootloader_V1_0TOV1_1.upd) to a freshly formated FAT32 SDCard.
-> Insert the SDCard into the emulator
-> Press Left and Right buttons before power up and keep it pressed at least 1 seconds at power up.
-> Wait some seconds. When 2 leds are blinking (Sdcard access led and Floppy Access led) it's done !
(to be sure wait 1 minutes before removing the power supply).

After this the firmware must be flashed. (Please go to the step 2: Firmware update)



2) Firmware update

-> Copy the new firmware file (*.upd) to a freshly formated FAT32 SDCard.
-> Insert the SDCard into the emulator
-> Press Left and Right buttons before power up and keep it pressed at least 1 seconds at power up.
-> Wait some seconds .... its done !



Note 1:
The file must be unfragmented on the sdcard and must be in the first part of the root directory.
For these reasons it is recommended to use a freshly formatted FAT32 SDCard, otherwise you may get the error 4 or 6 (see note 2).

Note 2:
Bootstrap LED error messages:
Error 1 : (blink 1 time and 2 seconds pause cycle) No entry point (->no software flashed)
Error 2 : (blink 2 time and 2 seconds pause cycle) SDCard init error.
Error 3 : (blink 3 time and 2 seconds pause cycle) FAT error.
Error 4 : (blink 4 time and 2 seconds pause cycle) UPD File not found!
Error 5 : (blink 5 time and 2 seconds pause cycle) Bad UPD File header! (bad file)
Error 6 : (blink 6 time and 2 seconds pause cycle) Bad data crc! (file corrupt)
Error 7 : (blink 7 time and 2 seconds pause cycle) Bad data size!
Error 8 : (blink 8 time and 2 seconds pause cycle) Write error (Pic flash error)


Jeff / HxC2001
[свернуть]

И где же теперь этот проклятый HxC_SD_Bootloader_V1_0TOV1_1.upd взять... А вот тут Jeff его таки прислал вопрошающему. Может там зарегаться и попросить?

---------- Post added at 01:17 ---------- Previous post was at 01:03 ----------

И чего я грею голову. Этот "недоступный" HxC_SD_Bootloader_V1_0TOV1_1.upd есть в архиве SDCard_HxCFloppyEmulator_firmware1303.zip! Ура!