Цитата Сообщение от Patron Посмотреть сообщение
Если сгенерить RT-11 с нестандартным консольным портом - можно выяснить задержку определения BREAK по тому моменту, когда тест, устанавливающий и (после задержки) снимающий BREAK - начнёт выносить 11/83 в пульт.
В этом случае придется или на ходу перетыкать провода или переконфигурять настройки чтобы загрузка была автоматической - сейчас он у меня в диалог входит.
На досуге надо панель переключателей сделать будет, а заодно всякие индикаторы и enable/halt туда вынести - последнего мне очень не хватает

---------- Post added at 01:02 ---------- Previous post was at 00:59 ----------

Хотя наверное проще попробовать с помощью PCшного порта реализовать нужное.
Завтра посмотрю что у меня там с памятью в 386м гробу - у меня вроде запасной дофига было к нему.

---------- Post added at 01:12 ---------- Previous post was at 01:02 ----------

Выдержка из описания DLV11-J:

Break Logic
During normal operation, the UART checks each received character
for the proper number of stop bits. It does this by testing for a marking
condition at the appropriate bit time. If it finds a spacing condition
instead, it sets the framing error (FE) flag. The BREAK signal is a
continuous spacing condition, and is interpreted by the UART as a
data character that is missing its stop bit(s). The UART, therefore,
responds to the BREAK signal by asserting FE H. If the channel 3
break response jumper is installed from X to B, FE H will negate
control line BDCOK H; BDCOK H indicates to the processor that dc
power is “OK.” When FE H negates this signal, it causes the computer
to restart at the bootstrap (provided proper processor power-up mode
is selected).
If the break jumper is installed from X to H, the computer will not
“boot” on a framing error, but FE H will negate control line BHALT L.
This causes the computer to halt when a framing error is received.

---------- Post added at 01:22 ---------- Previous post was at 01:12 ----------

Вобщем нету в DLV11 всех этих хитрых битиков какие есть в KDJ11. В TKS есть только готовность, прерывания и вот такой хитрый бит:
Код:
Bit: 0
Description: Reader Enable. Setting this bit advances the paper
tape reader on an LT33 terminal one character at a time. Setting of this
bit clears Receiver Done (bit 7). Write-only bit.
The DLV11-KA 20 mA current loop option is required for operation of
this bit.
TKB полностью идентичен DL11-W.

TPS - готовность, прерывания, break.

TPB - как обычно просто байт.

Для эмулятора ДВК самое оно