Добавил в [1,2]startup.cmd запуск decnet:
Код:
.SETT $CEX
.SETT $DEC
.SETT $NNS
ASN LB:=XX:
.SETF $LAT
@LB:[5,1]NETINS
и теперь при выполнении shutup.cmd не отмонтируется системный диск DB0:
Код:
>RUN $SHUTUP

RSX-11M-PLUS Shut down program
Enter minutes to wait before shutdown: 
Reason for shutdown (<CR> for none):
OK to shutdown? [Y/N]: Y

All further logins are disabled
22-JAN-16 10:59   System is now shutting down -- PISTON
QUE /STO:QMG
>
STOP/ACCOUNTING SHUTUP 
10:59:52  SYSLOG -- 47. Exiting
>
@LB:[1,2]SHUTUP

>VCP DISCONNECT /ALL
>@ <EOF>
>
ELI /NOLOG
>
ACS DB0:/BLKS=0.
ACS -- Checkpoint file now inactive
>
DMO DB0:/DEV/LOCK=V
DMO -- System disk being dismounted
DMO -- SYSTEM  dismounted from DB0:    *** Final dismount initiated ***
>
Command (DMO) Timeout - Continue waiting? [Y/N]: N
DMO NS0:/DEV/LOCK=V
DMO -- SYSTEM  dismounted from NS0:    *** Final dismount initiated ***
>

 Event type 68.14, Normal usage terminated
Occurred 22-JAN-16 11:00:13 on node 1.77 (PISTON)
Circuit UNA-0

 Event type 2.0, Local node state change
Occurred 22-JAN-16 11:00:15 on node 1.77 (PISTON)
Reason for state change: Operator command, Old node state = On
New node state = Off

SHUTUP operation complete
Это так и должно быть или перед shutup нужно отключать decnet?