Help building an Aleste remake board

[sebastian9922]

Hi guys this is my first post so like to say hello to everybody, and thanks for letting me in the forums

Now to business going to build an Aleste kit that got from Tetroid.


I like to know if this PCB requieres any corrections to it before building ?.
Also checked the shematics but don't see any place to feed power (+ and -) power input to the board where is the best place to do it ?.

Regards.

[Advertiser]

[goodboy]

don't see any place to feed power (+ and -) power input to the board where is the best place to do it ?

in the middle at right side (holes at c20)
http://www.cpcwiki.eu/index.php/Ales...X_-_Schematics

[sebastian9922]

in the middle at right side (holes at c20)
http://www.cpcwiki.eu/index.php/Ales...X_-_Schematics

Thank you very much for the info.
Do you happen to know if the pcb requieres any correction/fixes to it ?

[Willy]

Take a look at this topic, it might help you:
https://zx-pk.ru/threads/20769-kompy...20ex-quot.html

[sebastian9922]

Take a look at this topic, it might help you:
https://zx-pk.ru/threads/20769-kompy...20ex-quot.html

Thanks for the link Willy i have read the thread like 20 times using a translator, but the translation is terrible and is very hard to understand what is going on.

[Willy]

Try to ask directly in that thread, probably, people who assembled that board will help you.
Otherwise try to read it again starting from page 15, information about different components begins there.

[yuriy_sazonov]

Hello !
As I see you have a board version 1.004, which means that it does not needed any correction.
For the first start, I recommend not to install a coil "DR2"

[sebastian9922]

Try to ask directly in that thread, probably, people who assembled that board will help you.
Otherwise try to read it again starting from page 15, information about different components begins there.

Going to check again at that page, don't wanted to ask in English there not sure if the rules of the forum permit that.

- - - Добавлено - - -

Hello !
As I see you have a board version 1.004, which means that it does not needed any correction.
For the first start, I recommend not to install a coil "DR2"

Thanks for the information that was i needed to know before starting, also what about the coil "DR2" causes any issues ?.