Цитата Сообщение от vlad Посмотреть сообщение
(максимальная сила тока, потребляемого устройством по линиям питания шины USB, не должна превышать 500 мА)
Это после конфигурирования устройства, со старта кажись до 100 мА, для FT232 нужно в конфиг записать max current = 500 mA, точно название опции не помню...

---------- Post added at 22:56 ---------- Previous post was at 22:52 ----------

Код:
i)  On plug-in to USB, the device should draw no more current than 100mA. 
ii)  In USB Suspend mode the device should draw no more than 2.5mA. 
iii)  A bus powered high power USB device (one that draws more than 100mA) should use one of 
the CBUS pins configured as PWREN# and use it to keep the current below 100mA on plug-in 
and 2.5mA on USB suspend. 
iv)  A device that consumes more than 100mA cannot be plugged into a USB bus powered hub. 
v)  No device can draw more than 500mA from the USB bus.