Вид для печати
Hi guys this is my first post so like to say hello to everybody, and thanks for letting me in the forums :)
Now to business going to build an Aleste kit that got from Tetroid.
http://cats-chess.narod.ru/BOARD_SAL..._red_small.jpg
I like to know if this PCB requieres any corrections to it before building ?.
Also checked the shematics but don't see any place to feed power (+ and -) power input to the board where is the best place to do it ?.
Regards.
in the middle at right side (holes at c20)Цитата:
Сообщение от sebastian9922
http://www.cpcwiki.eu/index.php/Ales...X_-_Schematics
Thank you very much for the info.Цитата:
Сообщение от goodboy
Do you happen to know if the pcb requieres any correction/fixes to it ?
Take a look at this topic, it might help you:
https://zx-pk.ru/threads/20769-kompy...20ex-quot.html
Thanks for the link Willy i have read the thread like 20 times using a translator, but the translation is terrible and is very hard to understand what is going on.Цитата:
Сообщение от Willy
Try to ask directly in that thread, probably, people who assembled that board will help you.
Otherwise try to read it again starting from page 15, information about different components begins there.
Hello !
As I see you have a board version 1.004, which means that it does not needed any correction.
For the first start, I recommend not to install a coil "DR2"
Going to check again at that page, don't wanted to ask in English there not sure if the rules of the forum permit that.Цитата:
Сообщение от Willy
- - - Добавлено - - -
Thanks for the information that was i needed to know before starting, also what about the coil "DR2" causes any issues ?.Цитата:
Сообщение от yuriy_sazonov