Shockwav3, try this way:

rus

2. Положение сигнала INT:

По вертикали на 16 строк назад - всё как в Инферно-9 - отпаиваем одну ногу конденсатора C3 от 8 вывода DD6.3 (ЛИ3) и подаём на C3 этот же сигнал пропущенный через инвертор.

По горизонтали предлагаю сделать подругому:

Отрезаем дорожку от 14 вывод DD9 (ИЕ5), на 14 вывод DD9 подаём сигнал от дополнительной микросхемы 1533ТМ2, которую подключаем так:

На входы R и S (выводы 1 и 4) подаём +5в
На вход C (3 вывод) подаём сигнал с 3 вывод DD3 (ИЕ7)
На вход D (2 вывод) подаём сигнал SSI с 8 вывод DD14.3 (ЛП5).
Прямой выход ТМ2 (5 вывод) подключаем к 14 вывод DD9.
[свернуть]

eng

2. Position of the INT signal:

Vertically 16 lines back - everything is like in Inferno-9 - we unsolder one leg of the C3 capacitor from 8 pin of DD6.3 (LI3) and connect the same signal to C3 passed through the inverter.

Horizontally I propose to make another:

We cut off the track from the 14 pin of the DD9 (IE5), on the 14 pin of the DD9 we give a signal from the additional chip 1533TM2, which we connect as follows:

At the inputs of R and S (pins 1 and 4) connect to + 5V
At input C (3 pin), we give a signal from 3 pin DD3 (IE7)
To the input D (2 pin) we give a signal from 8 pin DD14.3 (LP5).
Direct output TM2 (5 pin) is connected to the 14 pin DD9.
[свернуть]

Try this way, but I think some fixes are necessary. The schematic diagram of the Pentagon 48 is very different in this part from the Pentagon-1024 or the GRM1.