Цитата Сообщение от b2m Посмотреть сообщение
Теперь вот думаю, правильно ли в этом случае считается Z
The zero flag has support for multi-byte zero: at each step it can AND the existing zero flag with the current ALU zero value, so the zero flag will be set if both bytes are zero. This is only used for the (undocumented) DSUB 16-bit subtract instruction. Strangely, this circuit is also activated for the 16-bit DAD instructions, but the result is not stored in the flag.

---------- Post added at 16:30 ---------- Previous post was at 15:38 ----------

Цитата Сообщение от Ramiros Посмотреть сообщение
а SIM/RIM нисходится никак, странно...
Если dk_spb еще не разобрал лабораторный стенд и готов выделить несколько минут, то можно сделать тест этих команд с отдельными CRC на каждый бит RIM.